Press Ctrl / CMD + C to copy this to your clipboard.
This post will be reported to the moderators as potential spam to be looked at
Good morning, people!
Did anyone face the same issue when installing The Starter Kit on Umbraco 10.2.1? I am getting the following after the installation is done and I just go with dotnet run in cmd:
It is not happening for ClenBlog starter kit, for instance.
is working on a reply...
This forum is in read-only mode while we transition to the new forum.
You can continue this topic on the new forum by tapping the "Continue discussion" link below.
Continue discussion
The Starter Kit Umbraco Cloud 10.2.1
Good morning, people!
Did anyone face the same issue when installing The Starter Kit on Umbraco 10.2.1? I am getting the following after the installation is done and I just go with dotnet run in cmd:
It is not happening for ClenBlog starter kit, for instance.
is working on a reply...
This forum is in read-only mode while we transition to the new forum.
You can continue this topic on the new forum by tapping the "Continue discussion" link below.